I know this is a German forum, but I can't find anywhere else to ask...
Yesterday I took my very old (2012) R40Li apart because it didn't start this year, it just gave me "Electronical error (501)". After a good cleaning of the connectors, it started again without a hitch.
But after I assembled it again, it would Stop for almost no vertical movement with the error "Lifted". I can get it going again by shaking it a little, but I don't have the reliability I'm used to.
What am I missing?
What can I check?
I've noticed that the magnet is covered with rust, but that shouldn't be a problem...?
[Gardena R40Li] Error says "Lifted" [WAITING FOR USER]
- shadowkiller
- Forum-Veteran
- Beiträge: 4475
- Registriert: Do 11. Jan 2018, 08:42
- Wohnort: Würzburg
- Mäher: Husqvarna Automower 315
- Firmware des Mähers (MSW): MSW 10.xx.xx
- Herstellungsjahr: 2017 (Modell 2018)
- Robonect-Modul: Robonect Hx (Rev.5)
- Robonect Firmware: 1.3 (WLAN 1.7.4)
- hat sich bedankt: 160 Male
- wurde gedankt: 135 Male
Re: [Gardena R40Li] Error says "Lifted"
This error often accours if the sensor (or the cable of the sensor inside the mower) for „lifted“ ist defect. Please check this - maybe by asking your mowers dealer.
- Folgende Benutzer bedankten sich beim Autor shadowkiller für den Beitrag:
- Moskus
- Bewertung: 14.286%
Anleitung zur Erstinstallation
--
Robonect® Dokumentation (= Gebrauchsanweisung = Bedienungsanleitung) und Support
--
Forum cooler nutzen: Hervorhebungen machen und Screenshots posten
--
Es wurde schon alles gefragt, nur noch nicht von allen. (frei nach Karl Valentin)
--
Robonect® Dokumentation (= Gebrauchsanweisung = Bedienungsanleitung) und Support
--
Forum cooler nutzen: Hervorhebungen machen und Screenshots posten
--
Es wurde schon alles gefragt, nur noch nicht von allen. (frei nach Karl Valentin)
- Moskus
- Forum-Anfänger
- Beiträge: 7
- Registriert: Do 29. Jun 2017, 08:58
- Wohnort: Norway
- Mäher: Gardena R40Li
- Firmware des Mähers (MSW): MSW 2.xx.xx
- Herstellungsjahr: 2011
- Robonect-Modul: Robonect Hx (Rev.4)
- Robonect Firmware: 0.9e
- hat sich bedankt: 1 Mal
- Kontaktdaten:
Re: [Gardena R40Li] Error says "Lifted"
Aha, thank you! I'll check if there's something wrong with it.