"Cables swapped!"

[arjepsen]

Hello.
I'm getting an error message on the robonect Status page, saying:

Robonect was not installed correctly!
The cables to the main board and the display were swapped! Correct this to be able to use all functions!

It does seem to work normally though, although I also get messages about undervoltage every now and then.

I did try swapping those two cables, but that resultet in robonect reporting a hardware error, and the mower becomming unresponsive.

Does anyone know what the problem might be?
(I'm using firmware 1.3, and it's a 430x)

[shadowkiller]

Maybe you have to disconnect Robonect completely OUT of your mover and look, if the mower works as described by the manufacturer.
Think on removing the batteries cable first at all when working inside the mover - why? Not doing often results in hardware defects like yours maybe. But not hoping so!