Aufgrund derzeit hohem Spamaufkommens werden neue Nutzer sehr restriktiv behandelt. Nach kurzer "Bewährungszeit" hat man als normaler Nutzer weitreichende Rechte und benötigt auch kein Captcha mehr.
.
Nutzer, die sich danach dennoch als Spammer oder Trolle erweisen, können jederzeit wieder auf diesen Status zurückgesetzt oder gebannt werden.
Dasselbe gilt für Versuche, politische Überzeugungen kund zu tun, egal aus welcher Richtung diese kommen.
.
.:!: Achtung! Derzeit ist Robonect (noch) nicht mit dem Automower 305 ab Baujahr 2020 zusammen mit der neuen Mäher-FW MSW 41.4.0 kompatibel!
Aber: Im DailyBuild ist ein Patch enthalten, der getestet werden kann! (Stand 15.02.2024)
.
.Du hast Deinen Gardena-Mäher auf die Gardena-Firmware von 2023 aktualisiert?
.:arrow: Testmöglichkeit für das Daily Build.

Das FW-Update am Mäher wird dennoch nicht empfohlen, da das Daily Build nach aktuellen Berichten von Beta-Testern noch keine vollständige Kompatibilität gewährleisten kann! (Stand: 15.02.2024)
Wir empfehlen, das Gardena-Update noch nicht durchzuführen!

.
.

Robonect Extension port - functions

Support für alle Mäher-spezifischen Fragen, die nicht unbedingt etwas mit einer Einstellung in Robonect zu tun haben und deshalb nicht zu einem bestimmten Menüpunkt passen.
Antworten
ldijon
Forum-Anfänger
Beiträge: 1
Registriert: Sa 20. Jun 2020, 22:42
Mäher: Husqvarna Automower 320
Firmware des Mähers (MSW): MSW 6.xx.xx
Herstellungsjahr: 2015
Robonect-Modul: Robonect Hx (Rev.5)
Robonect Firmware: 0.9c

Robonect Extension port - functions

Beitrag von ldijon »

Hello,
Since a couple of weeks, I'm a new owner of a Robonect device for my HUSQ 320. I'm looking for the functions associated to the 10 pins Extension port of the Robonect. I see TX & RX and Gpios.
- Is there any way to "program" the Robonect through the serial port and the GPIos ?
- Can it be used to send "commands" to the Robonect ?
- Is the Firmware of the Robonect Closed or Open ?

I have also a question about the large 20 pins flat cable of the Robonect:
- Is there any picture with the pinout of the large plug ?
- Is it documented / accessible ?

- On the HUSQ 320 mother board, there are 4 Aux ports (with TX/RX and power pins). Does any one of you have already explored what we can do with these ports ?

Thank you & have a great day,

Kind regards,

Luc

Antworten

Zurück zu „allgemeine Mäher-Frage?“