Aufgrund derzeit hohem Spamaufkommens werden neue Nutzer sehr restriktiv behandelt. Nach kurzer "Bewährungszeit" hat man als normaler Nutzer weitreichende Rechte und benötigt auch kein Captcha mehr.
.
Nutzer, die sich danach dennoch als Spammer oder Trolle erweisen, können jederzeit wieder auf diesen Status zurückgesetzt oder gebannt werden.
Dasselbe gilt für Versuche, politische Überzeugungen kund zu tun, egal aus welcher Richtung diese kommen.
.
.:!: Achtung! Verwendet bitte für aktuelle Mäher bzw. falls ihr die Firmware eures Mähers kürzlich aktualisiert habt, den aktuellen Release-Candidate der Robonect-Firmware: https://fw.robonect.de/?latest Diese wird in ein paar Tagen als offizielle Firmware verfügbar sein. (Stand: 03.04.2024)

[SOLVED] ROB 1000 -> winter

Support für alle Mäher-spezifischen Fragen, die nicht unbedingt etwas mit einer Einstellung in Robonect zu tun haben und deshalb nicht zu einem bestimmten Menüpunkt passen.
Antworten
risu
Forum-Nutzer
Beiträge: 32
Registriert: Di 11. Sep 2018, 11:39
Wohnort: France
Mäher: McCulloch ROB R1000
Firmware des Mähers (MSW): MSW 6.xx.xx
Herstellungsjahr: 2017
Robonect-Modul: Robonect Hx (Rev.5)
Robonect Firmware: V1.1b ROB 1000 test

[SOLVED] ROB 1000 -> winter

Beitrag von risu »

Also, the Robonect wifi is always on, even if the robot's main switch is off.
I fear it sucks the battery during winter :(
Zuletzt geändert von risu am Do 1. Nov 2018, 14:45, insgesamt 1-mal geändert.

Benutzeravatar
shadowkiller
Forum-Veteran
Beiträge: 4475
Registriert: Do 11. Jan 2018, 08:42
Wohnort: Würzburg
Mäher: Husqvarna Automower 315
Firmware des Mähers (MSW): MSW 10.xx.xx
Herstellungsjahr: 2017 (Modell 2018)
Robonect-Modul: Robonect Hx (Rev.5)
Robonect Firmware: 1.3 (WLAN 1.7.4)
hat sich bedankt: 160 Male
wurde gedankt: 134 Male

Re: ROB 1000 -> winter

Beitrag von shadowkiller »

No. In the Service tap of the Robonect menu you can completely shut down Robonect. When You startup the mower in spring, Robonect will also start again.
After this and switching off the main switch of Your mower, I recommend to pull off the batteries inside the mower (100% loading recommended by the manufacture, please see also his advices for winter). But before this all, I recommend to make Screenshots of all Your configurations in Robonect. So in case of loosing them (in case of a necessary factory reset), you'll be able to look for it easily, how they where before Robonect's shutdown for winter.
Anleitung zur Erstinstallation
--
Robonect® Dokumentation (= Gebrauchsanweisung = Bedienungsanleitung) und Support
--
Forum cooler nutzen: Hervorhebungen machen und Screenshots posten
--
Es wurde schon alles gefragt, nur noch nicht von allen. (frei nach Karl Valentin)

risu
Forum-Nutzer
Beiträge: 32
Registriert: Di 11. Sep 2018, 11:39
Wohnort: France
Mäher: McCulloch ROB R1000
Firmware des Mähers (MSW): MSW 6.xx.xx
Herstellungsjahr: 2017
Robonect-Modul: Robonect Hx (Rev.5)
Robonect Firmware: V1.1b ROB 1000 test

Re: ROB 1000 -> winter

Beitrag von risu »

Bild
Is is the option you're talking about ? Because the wifi hotspot is still ON while my robot is OFF.

I would remove the battery but it's not so cold, i can still test new firmwares :mrgreen:

Thank you !

Benutzeravatar
shadowkiller
Forum-Veteran
Beiträge: 4475
Registriert: Do 11. Jan 2018, 08:42
Wohnort: Würzburg
Mäher: Husqvarna Automower 315
Firmware des Mähers (MSW): MSW 10.xx.xx
Herstellungsjahr: 2017 (Modell 2018)
Robonect-Modul: Robonect Hx (Rev.5)
Robonect Firmware: 1.3 (WLAN 1.7.4)
hat sich bedankt: 160 Male
wurde gedankt: 134 Male

Re: ROB 1000 -> winter

Beitrag von shadowkiller »

Your Screenshot shows one possibility to shutdown Robonect. In my postings before I talked about the menu „Service“ in the robonect part of the robonect menu.
Tip: when the Robonect Webinterface is loaded, hold your cell phone in landscape view, then you’ll see all menu options.
Anleitung zur Erstinstallation
--
Robonect® Dokumentation (= Gebrauchsanweisung = Bedienungsanleitung) und Support
--
Forum cooler nutzen: Hervorhebungen machen und Screenshots posten
--
Es wurde schon alles gefragt, nur noch nicht von allen. (frei nach Karl Valentin)

risu
Forum-Nutzer
Beiträge: 32
Registriert: Di 11. Sep 2018, 11:39
Wohnort: France
Mäher: McCulloch ROB R1000
Firmware des Mähers (MSW): MSW 6.xx.xx
Herstellungsjahr: 2017
Robonect-Modul: Robonect Hx (Rev.5)
Robonect Firmware: V1.1b ROB 1000 test

Re: ROB 1000 -> winter

Beitrag von risu »

Oh, yes, my bad.
In the maintenance section i have a shutdown option. :oops:

After that, the module will be activated again the next time i switch on the robot ?

Benutzeravatar
shadowkiller
Forum-Veteran
Beiträge: 4475
Registriert: Do 11. Jan 2018, 08:42
Wohnort: Würzburg
Mäher: Husqvarna Automower 315
Firmware des Mähers (MSW): MSW 10.xx.xx
Herstellungsjahr: 2017 (Modell 2018)
Robonect-Modul: Robonect Hx (Rev.5)
Robonect Firmware: 1.3 (WLAN 1.7.4)
hat sich bedankt: 160 Male
wurde gedankt: 134 Male

Re: ROB 1000 -> winter

Beitrag von shadowkiller »

Sorry, my English maybe bad, but not as bad, you can’t read all!
shadowkiller hat geschrieben:...
When You startup the mower in spring, Robonect will also start again.
...
Anleitung zur Erstinstallation
--
Robonect® Dokumentation (= Gebrauchsanweisung = Bedienungsanleitung) und Support
--
Forum cooler nutzen: Hervorhebungen machen und Screenshots posten
--
Es wurde schon alles gefragt, nur noch nicht von allen. (frei nach Karl Valentin)

risu
Forum-Nutzer
Beiträge: 32
Registriert: Di 11. Sep 2018, 11:39
Wohnort: France
Mäher: McCulloch ROB R1000
Firmware des Mähers (MSW): MSW 6.xx.xx
Herstellungsjahr: 2017
Robonect-Modul: Robonect Hx (Rev.5)
Robonect Firmware: V1.1b ROB 1000 test

Re: ROB 1000 -> winter

Beitrag von risu »

I missed that, sorry :oops:
Thanks for the Support !

Benutzeravatar
shadowkiller
Forum-Veteran
Beiträge: 4475
Registriert: Do 11. Jan 2018, 08:42
Wohnort: Würzburg
Mäher: Husqvarna Automower 315
Firmware des Mähers (MSW): MSW 10.xx.xx
Herstellungsjahr: 2017 (Modell 2018)
Robonect-Modul: Robonect Hx (Rev.5)
Robonect Firmware: 1.3 (WLAN 1.7.4)
hat sich bedankt: 160 Male
wurde gedankt: 134 Male

Re: [SOLVED] ROB 1000 -> winter

Beitrag von shadowkiller »

You're welcome 8-)
Anleitung zur Erstinstallation
--
Robonect® Dokumentation (= Gebrauchsanweisung = Bedienungsanleitung) und Support
--
Forum cooler nutzen: Hervorhebungen machen und Screenshots posten
--
Es wurde schon alles gefragt, nur noch nicht von allen. (frei nach Karl Valentin)

Antworten

Zurück zu „allgemeine Mäher-Frage?“