Does anybody know how to access the module when away from home?
Is there a web address?
Control away from home [SOLVED]
-
- Forum-Nutzer
- Beiträge: 29
- Registriert: So 26. Aug 2018, 14:48
- Mäher: Flymo Robotic 1200R
- Robonect Firmware: -0.9c
Control away from home [SOLVED]
Zuletzt geändert von shadowkiller am So 23. Jun 2019, 13:59, insgesamt 1-mal geändert.
Grund: Titel an aktuellen Status angepasst
Grund: Titel an aktuellen Status angepasst
-
- erfahrener Forum-Nutzer
- Beiträge: 76
- Registriert: Di 17. Apr 2018, 11:04
- Mäher: Gardena smart SILENO
- Firmware des Mähers (MSW): MSW 10.xx.xx
- Herstellungsjahr: 2016
- Robonect-Modul: Robonect Hx (Rev.3)
- Robonect Firmware: 1.0
Re: Control away from home
There are basically two ways to do this.
1. Create a VPN on your home router if possible. Connect your mobile Device with that VPN and off you go.
2. Use a newer Firmware (still in Beta at the moment) this provides remote access to the module over a remote access server managed by the robonect developer Fabian
Important:
Don't do any port forwarding, too dangerous
If you don't know what a VPN is, forget about first point above. Without at least basic network knowledge also too dangerous as you might expose all your network gear to the open Internet and this will be hacked within minutes theses days.
So for the normal non IT guy the best solution is the remote access in the current Firmware Version 1.0 beta 7a
bye
Sven
1. Create a VPN on your home router if possible. Connect your mobile Device with that VPN and off you go.
2. Use a newer Firmware (still in Beta at the moment) this provides remote access to the module over a remote access server managed by the robonect developer Fabian
Important:
Don't do any port forwarding, too dangerous
If you don't know what a VPN is, forget about first point above. Without at least basic network knowledge also too dangerous as you might expose all your network gear to the open Internet and this will be hacked within minutes theses days.
So for the normal non IT guy the best solution is the remote access in the current Firmware Version 1.0 beta 7a
bye
Sven
WLAN 3* Ubiquiti UAP-AC-Lite APs