Seite 1 von 1
Cannot access robonect after a couple of days [TRY TO USE V1.6.2]
Verfasst: Fr 12. Jul 2019, 23:36
von Atman
Went fine for me as well and have been mowing for a couple of days. But now I cannot connect any more. It keeps mowing and the router has it connected (even after a power cycle) but I cannot access the web interface. With the robonect app I can get a glimpse of connection (it uses the API?) sometimes but it keeps losing it. What can i try?
Re: Cannot access robonect after firmware install
Verfasst: Sa 13. Jul 2019, 06:34
von shadowkiller
Hey,
You can
try to use some other devices to connect the local IP of Robonect in your
home WiFi
try to use another browser.
try to delete browser cache and cookies of robonect and then to reconnect.
try to change the channel of your AP connecting to Robonect.
try to connect the AP of Robonect if not switched off.
try to make a
PIN-Reset (please read the hint for this, the link is in my footer)
try to make a
Hardware-Reset (please read the hint for this)
This all in escalating order
and please tell us which one did help
Re: Cannot access robonect after firmware install
Verfasst: Sa 13. Jul 2019, 08:28
von 006fazer
Hi
I add this bug before update 1.7 wlan driver. The simple way to reconnect to lower is to disable and enable wlan on the router.
Re: Cannot access robonect after firmware install
Verfasst: Sa 13. Jul 2019, 08:33
von shadowkiller
You can also try the other release date version of the 1.7 WLAN driver ...
EDIT: You can try to downgrade to Driver version 1.6.2, too.
Any of this driver versions may solve your problem. Please report!
Re: Cannot access robonect after a couple of days [WAITING FOR USER]
Verfasst: Di 16. Jul 2019, 19:46
von Atman
Got it to work by moving the mower really close to the router antenna. I have the "earlier" of the wlan 1.7 drivers but it seems that it is less powerful than 1.6.2 (I think) that I had earlier.
I can send the logbook if you want. It is downloading now but the speed is about 2kbps (maybe a driver problem?)
Re: Cannot access robonect after a couple of days [TRY TO USE V1.6.2]
Verfasst: Di 16. Jul 2019, 19:55
von shadowkiller
You can try out V1.6.2 and go back to 1.7, if you want to test.